Ключевые слова: magnets dipole, LTS, NbTi, wires, quench protection, resistor, design, heat capacity, thermal conductivity, thermal expansion, experimental results
Ключевые слова: power equipment, FCL, circuit breaker, transformer current limiting, resistance, series connection, capacity, modeling
Ключевые слова: HTS, REBCO, cables, magnets, quench properties, heat capacity, temperature dependence, thermal conductivity, modeling, numerical analysis
Ключевые слова: REBCO, coated conductors, cable-in-conduit conductor, design parameters, fusion magnets, heat capacity, critical current, angular dependence, quench properties, thermal-hydraulics, normal zone propagation, RRR parameter, twist-pitch, contact characteristics, resistance, n-value, magnetic field dependence, HTS
Ключевые слова: HTS, Bi2223, tapes, coils pancake, permanent magnets, capacity, SMES, current distribution, test results, interaction
Ключевые слова: HTS, Bi2212, wires round, Rutherford cables, quench, magnets, coils racetrack, magnets dipole, winding configurations, heat generation, capacity, sensors, quench detection
Ключевые слова: HTS, Bi2212, wires, coils racetrack, design parameters, magnets, quench detection, quench protection, new, measurement technique, capacity, thermal runaway, time evolution
Ключевые слова: HTS, YBCO, coated conductors, modeling, current, dc performance, ac magnetic field dependence, quench, recovery characteristics, losses, dynamic resistance, shielding effects, frequency dependence, stabilizing layers, Cu-based conductors, thermal conductivity, heat capacity, design parameters, critical caracteristics, critical current, distribution, temperature dependence, current distribution, resistance, heat transfer, experimental results
Ключевые слова: wireless, power transfer, modeling, inductance, capacity, coils spiral, numerical analysis
Ключевые слова: power equipment, cables triaxial, cables underground, substation, loads, geometry effects, length, economic analysis, capacity
Ключевые слова: porosity, microstructure, X-ray diffraction, LTS, electrical conductivity, critical current density, capacity, energy conversion
Ключевые слова: HTS, YBCO, fabrication, sol gel process, mechanical treatment, annealing process, susceptibility, magnetization, heat capacity
Ключевые слова: power transfer, wireless, coils bifilar, coils spiral, converters, modeling, numerical analysis, capacity, frequency dependence, efficiency, experimental results
Ключевые слова: renewable energy systems, SMES, power distribution system, control systems, capacity, economic analysis, modeling, energy demand, distribution
Ключевые слова: HTS, YBCO, fabrication, phase formation, phase composition, X-ray diffraction, microstructure, heat capacity
Ключевые слова: LTS, Nb3Sn, wires multifilamentary, doping effect, heat capacity, stability, RRR parameter, flux pumps, quench energy, magnetization, microstructure, experimental results
Ключевые слова: SMES, capacity, control systems, modeling
Ключевые слова: power equipment, SMES, battery storage, control systems, modeling, capacity, frequency dependence, numerical analysis
Ключевые слова: quench detection, measurement technique, capacity, HTS, Bi2212/Ag, coils racetrack, nitrogen liquid , helium liquid, cryogenic systems
Ключевые слова: HTS, coils pancake, insulationless, design parameters, thermal stability, mechanical properties, quench, modeling, thermal conductivity, temperature dependence, heat capacity, current distribution, stress distribution, strain effects, pulsed operation, geometry effects, recovery characteristics
Ключевые слова: LTS, Nb3Sn, wires multifilamentary, composites, fabrication, doping effect, heat capacity, stability, magnets, HTS, review
Ключевые слова: power equipment, SMES, HTS, magnets, modeling, economic analysis, capacity, coated conductors
Ключевые слова: fusion magnets, high field magnets, forced flow, cooling technology, hydrogen, helium, neon, heat transfer, coils toroidal, HTS, REBCO, cables, current sharing, heat capacity, pressure drop, modeling, numerical analysis
Ключевые слова: HTS, YBCO, bulk, heat capacity, thermal stability, microstructure, experimental results
Akimov I.I., Keilin V.E., Kovalev I.A., Kruglov S.L., Shutova D.I., Kriukov D.A., Titov A.O., Shkolin S.A.
Ключевые слова: LTS, NbTi, Rutherford cables, fabrication, coatings, microstructure, heat capacity, stability
Ключевые слова: presentation, Japan, power equipment, HTS, DI-Bi2223, tapes, power transmission lines, cables three-in-one, cryogenic systems, grid operation, heat losses, capacity, degradation studies, plans
Keilin V.E., Kovalev I.A., Kruglov S.L., Potanina L.V., Shutova D.I., Salunin N.I., Vorobjeva A.E., Sсherbakov V.I.
Ключевые слова: Nb3Sn, Nb3Ge, LTS, lattice parameter, phase diagram, heat capacity, upper critical fields, Nb3Al, Nb3Ga, review
Ключевые слова: cryogenic systems, cryocoolers, fabrication, capacity, design, cooling technology
Grasso G., Ferdeghini C., Angurel L.A., Navarro R., Martinez E., Nardelli D., Romano G., Pelegrin J., Brisigotti S.
Ключевые слова: MgB2, tapes multifilamentary, PIT process, MgB2/Ni, MgB2/Cu/Fe, sheath, critical caracteristics, critical current, temperature dependence, resistive transition, resistivity, thermal conductivity, heat capacity, coils pancake, numerical analysis, minimum quench energy, quench propagation, experimental results
Ключевые слова: cryocoolers, cryogenic systems, heat capacity, numerical analysis
Ключевые слова: HTS, power equipment, cables, impedance, capacity, resistance, metropolitan application
Ключевые слова: HTS, YBCO, coated conductors, coils pancake, numerical analysis, modeling, quench propagation, thermal properties, thermal conductivity, heat capacity, temperature dependence, normal zone propagation, recovery characteristics, minimum quench energy, bulk, pulsed magnetization, trapped field distribution, new
Godeke A., Goldacker W., Dietderich D.R., Sumption M.D., Susner M.A., Dhalle M.M., Mentink M.G., Hellman F., Kate H.H.
Ключевые слова: nitrogen solid, cooling technology, cryostability, heat capacity, experimental results
Shikov A.K., Keilin V.E., Kovalev I.A., Medvedev M.I., Kruglov S.L., Potanina L.V., Shutova D.I., Salunin N.I., Vorobjeva A.E., Iljin A.A., Naumov A.V.
Ключевые слова: LTG process, NbTi, coils, composites, doping effect, heat capacity, stability, experimental results, numerical analysis, quench energy
Ключевые слова: cryogenic systems, nitrogen solid, NMR magnet, MRI magnets, LTS, Nb3Sn, MgB2, NbTi, HTS, YBCO, bulk, rings, heat capacity, neon, argon
Ключевые слова: HTS, coated conductor modules, mechanical properties, stress effects, strain effects, critical caracteristics, Jc/B curves, comparison, Bi2223, LTS, NbTi, Nb3Sn, capacity, presentation
Ключевые слова: cryogenic systems, refrigerator, stability, capacity, cooling technology, experimental results
Ключевые слова: HTS, magnets, cryogenic systems, cryogenic materials, heat capacity, vehicle applications, experimental results
Godeke A., Goldacker W., Dietderich D.R., Sumption M.D., Susner M.A., Dhalle M.M., Mentink M.G., Anders A., Hellman F., Putnam D., Slack J.L., ten Kate H.
Lin L.Z., Dai S.T., Qiu M., Xiao L.Y., Wang Z.K., Li X.H., Zhang G.M., Song N.H., Zhang J.Y., Zhang D., Zhang Z.F., Du X.J., Zhang F.Y., Zhou W.W.
Ключевые слова: MgB2, wires multifilamentary, critical caracteristics, critical current, temperature dependence, quench propagation, minimum quench energy, MRI magnets, design parameters, fabrication, stability, thermal conductivity, resistance, heat capacity, current-voltage characteristics, experimental results
Ключевые слова: HTS, bulk, pulsed magnetization, trapped field magnets, REBCO, trapped field distribution, flux density, capacity, experimental results
Shikov A.K., Keilin V.E., Kovalev I.A., Medvedev M.I., Kruglov S.L., Shutova D.I., Salunin N.I., Vorobjeva A.E., Potanina L.V.*21
Ключевые слова: LTS, NbTi, doping effect, heat capacity, wires multifilamentary, experimental results, fabrication, composites, critical caracteristics, coils, quench current, magnets, stability
Ключевые слова: HTS, YBCO, coated conductors, stabilizing layers, quench properties, recovery characteristics, nitrogen solid, heat capacity, cryogenic systems, conduction cooled systems, overcurrent, critical caracteristics, current-voltage characteristics, thermal stability, stability, experimental results
© Copyright 2006-2012. Использование материалов сайта возможно только с обязательной ссылкой на сайт.
Свои замечания и пожелания вы можете направлять по адресу perst@isssph.kiae.ru
Техническая поддержка Alexey, дизайн Teodor.